Used by movie studios, major theatre productions.

The spinner spins out rubber cement as a web  over a large area with an even flow. Rubber Cement is flammable when it spins out so don’t spray on an open flame. 

Once the rubber cement is dry (the solvent evaporates in around 20 minutes,  it is no longer flammable and totally safe. Feel free to light candles within the cobweb as the rubber left behind will just melt when in contact with flame. For thinner webbing, You could mix a 1:1 ratio of Rubber Cement and Thinners.

All you have to do is pour a small amount of the rubber cement into the cylinder, place the lid on and tighten with the rubber end cap screw, Attach it to your drill and you are ready to go! 

To clean the cylinder after use, use mineral spirits or Rubber Cement Thinner, Let stand in the cylinder for about 30 seconds with the lid on, then spin the remaining cleaner out the same way you used for rubber cement, and or rub off the remaining rubbery fluid with a rag or paper towel but be careful of sharp edges inside the cylinder.

After the Rubber Cement is  fully dry (about 10 min.), you can lighten the webs up with spray paint. Grey primer looks very good or you can use a lighter tan color. You can also use powder if you want realistic, dusty looking webs to your display.  The 20cm  blade was custom modified with a 37-degree pitch for a more projected airflow. 

Do not use on fabric or hair as the Rubber Cement will be very difficult to get off.   (Drill is NOT included!)

Metal Finish: Powdercoat Black Cylinder / Metal / Anodized  blades.  Includes instructional video.  $235.00

Rubber Cement and Solvent is available at art supply stores.